The Hair Studio - HAIR CONSULTATIONS, WASH AND BLAST DRY

Equipment used:

Gown

Towel

Shampoo

Conditioner

Wide tooth comb

Hair dryer

How to make a HAIR CONSULTATION

Looking at the natural hair state of your model, check for dandruff, alopecia (when hair is missing), head lice (usually sit at the nape of the neck and behind the ears), type of hair and the condition of the hair

Ask if they are on any medication, as this would affect the way that the hair is and ask if they have any allergies

How to WASH and BLAST DRY hair

Begin by putting a gown on your model and a towel around their neck

Ensure that all hair is in the sink basin and then turn the tap on, checking the water temperature on your wrist

Rinse the hair with water, being careful not to drip it on the face

Put shampoo into your hands and massage into the head using our fingertips

NOTE: with fine hair use less shampoo and with think hair use more shampoo and do not scrub the hair with shampoo

Repeat the shampooing process twice

Rinse the hair clean of shampoo.  The hair will squeak when it is fully rinsed

Turn off the water after shampooing

Put conditioner into your hands and onto the hair, not putting too much at the roots

Comb through the hair at the basin using a wide tooth comb whilst the conditioner is on

Rinse the comb of all conditioner and rinse the hair thoroughly

Squeeze the hair to get rid of any excess water and wrap the hair in a towel, squeezing once more – do not rub.

Using the wide tooth comb again, comb through the hair in sections

NOTE: never brush wet hair, always use a comb

Place the nozzle on the hairdryer and ensure that there are no knots in the lead

Begin to dry the hair, moving the hairdryer around from root to tip, running your fingers through the hair to make sure that you get every section

NOTE: the thicker the hair the higher the heat and the finer the hair the lower the heat